Following the same approach as used for the O/S the N/S side panels have been aligned, clamped, measured and drilled:
The plan is to get some of the panels powder coated on the inside surfaces (at least), to match the chassis, and provide a consistent interior colour and finish for the passenger compartment. I'll see how this turns out.
Once the floor panels are powder coated I can get them fitted and sealed at which point the chassis can stay the right way up and I can fit a lot of the suspension, diff etc.
FSC delivered some more parts a while ago, the rear uprights (along some other smaller parts):
And the first FSC supplied Duratec exhaust manifold (although it may be missing a Lambda sensor mounting boss, I need to check whether the sensor mounts instead into the silencer...):
No comments:
Post a Comment